SI2000 Proteus932 IAD Firmware Update

[mikismajs]

Hočem si naredit firmware update na svojemu Proteusu, ampak ko kliknem na Avtomatically check for updates in potem na gumb Check for updates > mi javi error: Protocol not supported. Na strani od iskratela pa ga ne najdem. Prosim pomoč. Kateri protocol? Ali je to mišljen service od operacijskema sistema?

Imam linijo 5/5 VDSL, ampak mi v bistvu upload deluje samo tam okoli 200 KB. Download deluje v redi.

API Version 1.01
Firmware Version 1.66.31
Dsp Version 0x0000000a
Operational mode All
State Showtime
Trained transmit bit rate 5248 kbps
Trained receive bit rate 5248 kbps

Upstream power 0.4 dB
Local Fast channel FEC error count 0
Local Interleaved channel FEC error count 0
Local Fast channel CRC 0
Local Interleaved CRC 0
Local line attenuation 86.5 dB
Local signal-to-noise margin 92.5 dB
Local LOS 0
Local SEF 0

Remote Fast channel FEC error count 0
Remote Interleaved channel FEC error count 0
Remote Fast channel CRC 0
Remote Interleaved CRC 0
Remote line attenuation 0.0 dB
Remote signal-to-noise margin 0.0 dB
Remote LOS 0
Remote SEF 0

Pokliči na 0801000 in ti ga obnovijo.

[080 Urban]

Imaš nadgrajeno.

lp

[1xx]

Objavil-a 080 Urban

Imaš nadgrajeno.

lp

Katera pa je zadnja verzija in kako se nadgradi firmware? Tudi jaz bi nadgradil, vendar se mi v meniju ta opcija ne pokaže. Trenutni FW pa je 5.0.27b15-3.14b1-1.66.31

[080 Urban]

Daj mi up. ime na ZS.

lp

[Nekdo25]

Malo obujam temo...
Zanima me, če je kaj narobe, če imam tako nizek Local signal-to-noise margin?

API Version 1.01
Firmware Version 1.66.31
Operational mode All
State Showtime
Trained transmit bit rate 2496 kbps
Trained receive bit rate 11968 kbps

Upstream power 6.5 dB
Local line attenuation 9.3 dB
Local Interleaved channel FEC error count 0
Local Interleaved CRC 0
Local signal-to-noise margin 1.4 dB
Local LOS 0
Local SEF 0

Remote Interleaved channel FEC error count 0
Remote Interleaved CRC 0
Remote line attenuation 0.0 dB